PHOENISING
Stainless Steel Flux Cored MIG Welding Wire E308LFC-O, .035-Inch Diameter, 2-Pound Spool
Stainless Steel Flux Cored MIG Welding Wire E308LFC-O, .035-Inch Diameter, 2-Pound Spool
Couldn't load pickup availability
Request a Quote
* All fields are required
E308LFC-O Flux Cored: Stainless steel wire features an internal flux core to stabilize the arc and provide a self-shielding, protective barrier for strong, reliable welds.
All-Position Welding: Engineered for high productivity with continuous feed, offering smooth arc action and excellent operator control for flat, horizontal, vertical, and overhead welds.
Gasless Versatility: Self-shielding design eliminates the need for external shielding gas, making it ideal for portable use and effective in outdoor or windy conditions.
Stainless Steel Compatibility: Specifically for welding common austenitic grades, including 304, 304L, 308, 308L, 321, and 347, ensuring corrosion-resistant welds.
Durable Spool: Supplied on a 2-pound, .035-inch diameter strong ABS plastic spool that is robust and anti-fragile for flawless feeding and long-term durability in your machine.
Q: Can I run this on my 120V household welder?
Q: Can I run this on my 120V household welder?
A: Yes, but .035" stainless wire takes quite a bit of power to melt properly. For the best results on a 120V machine, use a 20A circuit and set your voltage to the highest setting. If the machine "stutters," you may need to switch to a 240V machine or the .030" diameter wire.
Q: What polarity should I use for this stainless wire?
Q: What polarity should I use for this stainless wire?
A: This is a self-shielded wire, so it typically runs on DCEN (Electrode Negative). Check your machine's internal taps and make sure the ground clamp is in the Positive (+) terminal.
Q: Will this weld 316 stainless?
Q: Will this weld 316 stainless?
A: It will bond to 316, but for maximum corrosion resistance in marine environments (saltwater), you should ideally use an E316LFC-O wire. E308L is the standard for 304/308 stainless (the most common type).
Q: How do I get the black "soot" off the weld?
Q: How do I get the black "soot" off the weld?
A: You must use a Stainless Steel Wire Brush. Do not use a standard carbon steel brush, as it will embed tiny particles of mild steel into your stainless, which will cause the weld to rust. For a professional finish, follow up with a "pickling paste" or a flap-disc grinder.
Q: Is the slag self-peeling?
Q: Is the slag self-peeling?
A: Sometimes, but not always. Stainless flux-core slag is often "glassy" and brittle. It may "pop" off as it cools—always wear safety glasses, even after you stop welding, as the cooling slag can jump off the metal.
Q: Why does the wire keep melting back to the contact tip?
Q: Why does the wire keep melting back to the contact tip?
A: Stainless steel is less conductive and holds heat longer than carbon steel. If this happens, increase your wire feed speed or increase your stick-out (the distance between the tip and the metal) to about 5/8".
