PHOENISING
3/32" E6013 Carbon Steel Welding Rods, 10LB Pack, All-Position Stick Electrodes for AC/DC Welder
3/32" E6013 Carbon Steel Welding Rods, 10LB Pack, All-Position Stick Electrodes for AC/DC Welder
Couldn't load pickup availability
Request a Quote
* All fields are required
1, Welds in All Positions with low spatter and minimal penetration, making it ideal for poorly fitted joints and general purpose repair.
2, 10-Pound Pack of 3/32-inch diameter stick electrodes offers reliable, self-releasing slag for an excellent, virtually self-cleaning welding experience.
3, Designed for Versatile Use on AC or DC welding currents, providing stable operation even with low-voltage AC machines.
4, E6013 Mild-Steel composition is suitable for general fabrication, light-gauge metal, sheet metal, and various duct work applications.
5, Recommended Amperage range of 45A-90A provides optimal performance and a smooth arc for beginners and experienced welders alike.
Q: I’m using a 120V welder; will these work on a standard wall plug?
Q: I’m using a 120V welder; will these work on a standard wall plug?
A: Yes. The 3/32" diameter is ideal for 120V machines. Set your welder between 60A and 80A. If you use a 1/8" rod, you will likely trip your household breaker, but these 3/32" rods are designed for that lower power range.
Q: Can I use these to weld a lawnmower deck or a tailpipe?
Q: Can I use these to weld a lawnmower deck or a tailpipe?
A: Absolutely. These are "shallow penetration" rods, meaning they sit on top of the metal rather than digging deep. This makes them the best choice for thin materials like mower decks and exhaust tubing where you want to avoid "blowing holes."
Q: Should I use a "scratch start" or a "tap start" with these?
Q: Should I use a "scratch start" or a "tap start" with these?
A: E6013 responds best to a "match-strike" motion (scratching). Because the 3/32" is thin, tapping it too hard can crack the flux coating off the tip, making it even harder to start.
Q: Why does the slag look like it’s "boiling" while I’m welding?
Q: Why does the slag look like it’s "boiling" while I’m welding?
A: That is normal for E6013. It has a high-titanium coating that produces a lot of slag to protect the weld. Keep your arc tight and keep the puddle moving; once it cools, that "boiling" mess will turn into a clean, shiny bead.
Q: Do I need to keep these in a heated rod oven?
Q: Do I need to keep these in a heated rod oven?
A: Not necessarily, but you should keep them in a dry, airtight container. If you live in a humid area (like the US South or Midwest), damp rods will cause the arc to "hiss" and "spatter." If they get damp, you can dry them in a kitchen oven at 200°F for an hour.
